4Bros Safariland Taser 7 & Taser 10 Molle Adapter

Our goal in developing the third revision of our Molle Adapter was simple: offer a low-cost, effective, and solid mount to convert the Safariland Taser 7 and Taser 10 holster to a load-bearing vest that consumes only two rows of Molle, keeps the holster tight to the chest, and retains the retention hood function.

We have achieved that by creating a user-installed system that includes the common hardware needed for quick, simple installation. 

Written installation instructions are HERE.

Video installation instructions are HERE.

The adapter WILL ALLOW CANT, however, you must remove the Molle Loks to adjust the angle. 

The adapter plate strength pull was tested to withstand an excess of 100 pounds of force. (The Actual failure was around 300 pounds, which exceeded our validation capabilities.) 

If you have questions regarding the compatibility of your holster and our adapter, we suggest reading the instruction links below for quick answers. If you do not find the information you need, please feel free to reach out through the Contact Us section of the website. We will answer your questions as quickly as possible.  

We STRONGLY suggest using Loctite 242 or Vibra-Tite 121 or VC-3 thread locker on all screws during the final steps of the installation. Once installed with a thread locker, this system will be difficult to unassemble. Please make sure you have it dialed into your personal preference before adding the thread-locking product

Terms and conditions: By purchasing this product, you take full responsibility for the correct installation of the adapter to your gear. We will not be responsible for incorrect installation.